Liming Stamping Form Machine Co.,Ltd
Your industry is our industry
Add to Cart
The pressed steel plate that supports the floor concrete is called the floor deck. The floor deck has the advantages of large waviness and high strength. It is widely used in automobile exhibition halls, steel structure factories, cement warehouses, steel structure offices, etc. Steel structure construction. If you need to produce floor decks, our company can provide you with floor deck forming machines
The floor deck forming machine produced by our company adopts advanced hydraulic drive, automatically cuts after forming, does not deform, has no waste, and has the characteristics of high safety factor, which can help you avoid potential safety hazards.
The floor deck forming machine is also equipped with a high-intelligence industrial electronic programmer PLC inverter control system, which is simple to operate, accurate and stable in performance. The length accuracy is less than 2mm, which can help you produce high-precision floor deck products.
At the same time, the floor deck products produced by the floor deck forming machine have simple shapes, large waviness, high strength, and good adhesion, which are well received by the engineering industry.
Main parameters ofProject contracting, fast construction, easy to install, deck floor roll forming machine
| Raw material | |
| material spec | GI,GL,PPGI,PPGL |
| Thickness of coil sheet | 0.4-1.2mm |
| Machine details | |
| Roller material | l Forming rollers adopt 45# steel,.And surface of rollers is grinded,polished and hard chromium plating with high precision.To ensure the smoothness of the chamfer, reduce the friction between the plate and rollers, and reduce the damage of the paint surface of the plate. |
| Shaft material | Shafts of forming adopt 45# steel,after balance correction,are grinded,polished with high precision. |
| Stainless steel dust shield is mounted on the outside of the bearings. | |
| Diameter of shaft | 75mm |
| Main frame | 350 H steel |
| Forming steps | 18 rows |
| Productivity | 25m/min |
| Hydraulic station power | 5.5 KW |
| Controlling system | famous PLC computer control |
| Material of cutting table | Cr 12 mould steel with quenched treatment |
| Appearance size | 6500mm*1500mm*1300mm |
| Hydraulic oil | 40# hydraulic oil |
| Electric tension | 440V 50 Hz 3 Phase or as your requirements |
